The sand will be natural looking and it will finish off the job nicely. Once the wood strips are in place, fill any small gaps between the wood and the concrete slabs with medium sand. In fact, I would dip the end of each piece of wood into the can of the sealant for at least two minutes allowing the water repellent to be drawn deeply into the end grain. It's very important that the ends are well coated. This dimension allows the wood to be recessed below the top of the slabs about 1/4 inch.īefore you install the wood, completely coat all the sides, edges and ends with three coats of a high-quality synthetic resin water repellent. ![]() Each strip should be cut so that it's 1 3/4 inches from top to bottom.
0 Comments
Leave a Reply. |